Introduce the Installation Steps of the LED Light Source Module

LED light source module installation step 1. The number of light sources modules is used in equal amplitude discharge, which simulates the distribution of light source modules on the computer. The number of light source modules required for preliminary budgets. The module spacing visual brightness needs to be between 3-150px. The thickness of the word can be selected between 5-325px. 2. Calculate the power power, the number of LED light source modules with a budget for power distribution solutions The power of a single light source module = total power consumption power. It is recommended that the power supply should be available to have a balance, and use the rated power of 80%to use. 3. Install the LED light source module A: clean the surface; B: use double -sided non -dry glue to stick to the bottom of the module; C: uniformly discharge, connect to : Precautions for the LED light source module of the finished product 1. The polarity of the LED module: the red line connects the power supply, the white line connects the power supply negative pole. 2. The vertical height of the acrylic light -transmitting cover is greater than 5 cm from the LED module, less than 13 cm to avoid the phenomenon of light spots or dark phenomenon on the surface of the cover; It has a great impact on uniformity, you need to pay attention to the choice. 3. Work voltage: Pay attention to the voltage consistency of the voltage of the LED light source module to the voltage of the switching power supply. 4. Firm paste: Make sure that the LED module pasted in the light box is firm and reliable, and fix it with screws if necessary. 5. The length of the wire: the length of the power cord is as short as possible (it is recommended not to exceed 3 meters), greater than or equal to 18AWG#, and more than 3 meters should be appropriately increased. The above is the introduction of the device of the LED light source module. The device of the light source module is still relatively simple. The principle bureau can be installed faster and better. In addition to pay attention to its principle, we also need to look at the precautions of the device of the light source module, so that the light source module can be installed better.