[UVLED] UVLED Curing Device When Encountering Common Problems, Solutions

As a 11 -year -old manufacturer specializing in the production of UVLED curing machines in 11 years, Tianhui will continue to popularize some knowledge about UVLED optical curing equipment for free. UVLED optical curing equipment has attracted everyone's attention in recent years. It has excellent performance and efficient and energy -saving characteristics. After all, the device is the device. During the use process, factors such as frequency and maintenance methods will affect the performance of the UVLED optical curing machine. It is inevitable that a little problem is a little bit problematic. You dont have to worry about it. Unusual solution! First, the UV light of the UVLED device is not on or self -extinguished. If this problem occurs, first think of whether the UVLED light is aging, you can consider changing the UVLED light. In fact, it is not necessarily that the UVLED light is broken. If you are the UVLED optical curing machine of Tianhui you buy, you can see the display interface of the controller and operate according to the interface prompts. The UVLED device lights are not on. There are several reasons for the following aspects: 1> UVLED devices have abnormal signal input: such as high temperature alarm, traffic alarm, etc.; In this case Turn, whether the water -cooled machine is working normally, and is the water pipe blocked?. If the fan does not turn or the water cooling machine is abnormal, contact UVLED device manufacturer. 2> UVLED device circuit failure: If the cable is not tightly inserted, the internal circuit failure of the UVLED device, etc.; The cable is connected again, and the abnormality is still not resolved. There is a control power supply, but it cannot light up the UVLED light and the control panel abnormal light is not turned on before it is considered whether it is caused by the melting of the UVLED curing machine main circuit fuse. Then check whether the main circuit has a loose or short -ground circuit. Sometimes this phenomenon will appear when UVLED lights are old or deteriorated. If it is a device circuit failure, refer to the second point of the first point to solve it! Third, when the equipment is too high, when the temperature is too high, you must first consider whether the heat dissipation is not good. First check whether the fan runs normally, and clean up the dust at the fan. Using the environmental temperature is relatively high or the environment is harsh, Tianhui recommends that you can choose to buy a water -cooled UVLED curing machine to avoid the emergence of this situation. These three problems are more common when using UVLED curing devices, and the solution is relatively simple. I hope it can be helpful to everyone. If you also have questions about UVLED solidification, you can leave a message to Tianhui or directly call to consult and communicate!