[UV CICS] Talking About the Application of UV Three Anti -paint and Its Curing

The three anti -lacquer three -proof contains mildew, moisture -proof, and salt -proof fog. It is generally used in the protection of electronic circuit boards and their electronic components. These circuit boards are generally used in more complex environments, such as industrial and mining instruments, kitchen appliances, outdoor street lights, etc. The three -proof paint is sprayed on the circuit board and electronic components to protect it, which greatly extend its service life. Protecting, increasing electrical insulation protection, is also a guarantee for users' safety. UV three -proof is a single -component ultraviolet curing electrical rubber. It can generally be cured with light (ultraviolet) and moisture (water in the air). Therefore. Why use dual solidification? Because in many applications, because the coated place is relatively narrow or obstructive, the light cannot be illuminated to the place, and the coatings where the light cannot be illuminated will be solidified by absorbing the trace water in the air to solidify the moisture solidification. UV three anti -paint is waterproof and shock resistance. The salt and fog resistance and breakdown intensity are stronger than other three anti -paint. In light curing, UV three-proof paint use UVLED curing lights with a wavelength of 365nm are generally used. The required light intensity is generally not high. It is generally about 400-800MW/CM2, 3-5 seconds of curing time for 3-5 seconds , Mainly noodle light sources. Tianhui's UVLED face light source adopts imported UVLED lamp beads, high -quality constant stream sources, and excellent heat dissipation design. It has the advantages of compact, high reliability, and high stability.