Many customers consult Tianhui, how can I get their best service life? Here, tianhui will give you a little answer! In fact, the service life of any item is related to whether it is properly maintained. For example, if the car is not maintained in accordance with the regulations, various unexpected problems will occur, and it will even lead to a traffic accident. The UVLED curing machine is no exception. Although the accident does not occur, it will cause the production line to be downtime and it cannot be produced normally! As a new type of energy -saving device, UVLED solidified light source has been recognized and liked by customers. UVLED's energy -saving environmental protection and high efficiency are emerging products that replace traditional mercury lamps. For this product, we must pay attention to the maintenance of it to improve the service life. The heat dissipation of the UVLED curing device illuminates. We all know that UVLED is the light emitting diode, and UVLED is ultraviolet light emitting two tubes. UVLED light emitting mechanism: The end voltage of the PN knot constitutes a certain position. When the positive bias voltage decreases, most of the carrier of the P and N zone spreads to the other party. Because the electronic migration rate is much greater than the air acupoint migration rate, a large number of electronic spreads to the P area, forming an injection of a minority carrier of the P area. These electrons are compounded from the cave on the price, and the energy obtained during composite is released in the form of light energy. This is the principle of PN knot glow. Therefore, a large amount of heat will produce when glowing. When using the tianhui wind and cold illumination head, it is necessary. Maintenance of TianhuiuVled equipment in Zhuhai City. 1. Use this machine in harsh environments such as drying, ventilation, no high magnetic field. 2. In the process of litting the UVLED process, do not perform parameter settings, UVLED irradiation head plugging and other actions. 3. Please do not disassemble the UVLED irradiation head and controller to avoid causing UVLED light leakage or damage to the machine. 4. Please do not shoot your eyes or skin directly to UVLED, so as not to cause damage. 5. When regularly cleaning the UVLED light and controller, please do not use chemical materials such as diluents, propylene glycol, and use a soft cotton cloth to dip a small amount of ethanol to wipe carefully.
Author: Tianhui-Air Disinfection
Author: Tianhui-UV Led manufacturers
Author: Tianhui-UV water disinfection
Author: Tianhui-UV LED Solution
Author: Tianhui-UV Led diode
Author: Tianhui-UV Led diodes manufacturers
Author: Tianhui-UV Led module
Author: Tianhui-UV LED Printing System
Author: Tianhui-UV LED mosquito trap