Introduce the Instructions for the Use of LED Light Source Modules

The LED light source module is based on any form of application to large -limit optical design, heat dissipation design, shape, size design, and interface standardization design. The above design is used to achieve the standardization combination of different application places lamps to achieve convenient use and basis Life can replace the function of the module, and to largely reduce the cost of user costs. And the color rendering index (the ability to reproduce the real color) as one of the three important indicators to measure the quality of the white light source, and it is also an important criterion for measuring whether the LED light source module is healthy. The position in various indicators in the field of lighting is particularly obvious. Instructions for use: 1. At this stage, the light source of the light -emitting characters is mainly commonly set in the input voltage of LED, five lights, and six lamps with the input voltage of DC12V. Therefore, if you do nt install the switching power supply when installing the light -emitting character, do nt do nt directly power the light or light source module into the market. 2. In order to avoid the long -term load work of the switching power supply, the switching power supply and LED load power is better at 1: 0.8, and the service life of the product will be more secure and long -lasting according to this. 3. If the module exceeds 25 groups, it should be connected separately, and then connects to the light -emitting box in parallel from high -quality copper core wires greater than 1.5 square millimeters. Increase the line diameter. In order to avoid short circuits, the end of the module must be cut and pasted. At the same time, if necessary, use a self -attack screw and waterproof series outdoors if necessary. Brightness, the module spacing visual brightness requires the thickness of the words between 3 and 6cm, which can be selected between 5 and 15cm. 5. In the process of using the LED light source module, be sure to pay attention to the problem of voltage drop. Never do only one loop, from the first series of connecting tail. This will not only make the brightness inconsistent due to the different voltage between the first and tails, but also the problem of excessive single -circuit current burning the circuit board. The correct approach is to connect as much as possible to ensure that the voltage and current distribution is reasonable. 6. If you need to use anticorrosive materials inside the word cavity, try to use white primer to increase its reflection coefficient.